GVS EIB / KNX USB interface

0 Review(s) 
BNUS-00/00.1
New product

The KNX USB Interface is designed for an intelligent building control system, which is used for facilitating communication between the PC and the KNX system.

Programming Cost .
€186.00
Tax excluded

ZD4i%20Multisensore%20Zhaga%20Light%20Controller%20Ouydoor%202.jpg

The KNX USB Interface connects a PC to an EIB/KNX system via a USB socket type A in the front and a USB interface extension cord, in order to configure, parameterize and commission the EIB/KNX installation as well as bus monitor using the ETS (ETS3 or later) software.

The maximum communication distance is 5m between the PC and the communication interface. 

The communication interface of the KNX USB Interface is a USB standard 2.0 type A, and uses a standard USB connection way with a PC. 

The KNX USB Interface has not an application program, but it is able to use the Engineering Tool Software ETS (ETS3 or later) to allocate the physical address. The factory default physical addresses are 15.15.255.

Note — — a KNX drive program (GVS USB driver for KNX.exe) need to be installed in the PC, or else the interface cannot connect to the PC.

BNUS-00/00.1
New product

You might also like

Reviews

Write your review

EIB KNX bus cable ring 100m green EIB-Y(St)Y 2x2x0,8

Write your review