ABB EIB / KNX Blind/Roller Shutter Actuator with travel detection 8CH MDRC (8 DIN)

0 Review(s) 
JRA/S8.230.5.1
New product

The 8-fold Blind/Roller Shutter Actuators with travel detection and manual operation are used to control independent 230 V AC drives, for positioning blinds, roller shutters, awnings and other shading products,doors, windows and ventilation flaps.The travel times of the drives are automatically determined via end position detection and stored.

Programming Cost .
€404.99
Tax excluded

ZD4i%20Multisensore%20Zhaga%20Light%20Controller%20Ouydoor%202.jpg

The devices are used for control of motors (230 V AC) with sun protection products, such as blinds, roller shutters, Venetian blinds, awnings, roller blinds, curtains, vertical blinds, etc. The fully automatic control takes into consideration the time of day, the strength of the sunlight, the temperature conditions, the wind force etc. The shutter/blind is positioned in accordance with these factors.

Function____________________________________________________________

  1. Manual function :
  • Disable/enable man. operation 
  • Manual operating status

Operating modes :

  • Control with slat adjustment (blinds, etc.)
  • Control without slat adjustment (roller shutters, awnings, etc.)
  • Ventilation flaps, switch mode

Direct functions :

  • Up/Down/Stop
  • Slat adjustment
  • Position height/slat 0…255
  • Preset Move to position/Set position
  • Up/Down limited
  • Enable limitation
  • Trigger travel detection
  • Trigger reference movement
  • 8 bit scene

Safety functions :

  • Wind ,Rain,Frost alarm
  • Block
  • Forced operation
  • Reaction after bus voltage failure, recovery and programming

Status messages :

  • Status height/slat 0…255
  • Status upper/lower end position
  • Status of operation
  • Status automatic control
  • Status information (2 byte)
JRA/S8.230.5.1
New product

Reviews

Write your review

ABB EIB / KNX Blind/Roller Shutter Actuator with travel detection 8CH MDRC (8 DIN)

The 8-fold Blind/Roller Shutter Actuators with travel detection and manual operation are used to control independent 230 V AC drives, for positioning blinds, roller shutters, awnings and other shading products,doors, windows and ventilation flaps.The travel times of the drives are automatically determined via end position detection and stored.

Write your review