Integrates an indoor Daikin climate unit  with KNX system.Five operating modes (auto, heat, cold,  ventilation and dry). Three fan speeds (low, medium, high). Includes energy saving mode. Arithmetic-logic unit and timers/counters. 

A KNX device for measuring Alternating Electrical Current. This device measures the alternating current absorbed on an electrical line and indirectly provides the power values that can be used to determine the amount of electrical power consumed.The 3 channels can be programmed independently by ETS to carry out energy saving operations. Current clamps not included 

Electric consumption meter of up to three channels. Possibility of establishing consumption limits. Alarm function in case of leaving the thresholds. Interference to procedures of the interfaces of Bes and Apps of Ingenium. Not Included 3 Current transformer of 40A. Optional (60A)

Scarica DATASHEET

Scarica  MANUALE 

IT is a bidirectional meter for measurement of active and reactive energy or power, respectively. Further it features an analysis of power supply quality.Measurements can be performed in a 3-phase system or in three independent 1-phase system.(current, voltage, active power, reactive power, active energy, reactive energy, power factor, THD-U, THD-I harmonics, unbalanced load, zero system current) 

Electric consumption meter of up to three channels. Possibility of establishing consumption limits. Alarm function in case of leaving the thresholds. Interference to procedures of the interfaces of Bes and Apps of Ingenium. Included 3 Current transformer of 60A.

Scarica DATASHEET

Scarica  MANUALE 

The current clamp enables the absorption on a power line to be measured by induction without the need to switch off the power,because it has a spring mechanism that allows it to be attached to cables with a maximum diameter of 13mm. The clamp has a sensitivity of 60A/V and allows the instrument to measure electrical current up to a maximum value of 150A.