GVS EIB/KNX Switch Actuator 12CH 16A Current Detection (12 DIN) ARCD-12/16.1

GVS EIB/KNX Switch Actuator 12CH 16A Current Detection (12 DIN) ARCD-12/16.1

GVS
KA/R 12.16.1
New

The switch actuators are the modular installation devices, with 2, 8 and 12 outputs for selection, using EIB BUS connection terminals to connect to the system. The switch actuators are connected to the AC power supply directly instead of an extra voltage supply. 

Programming Cost . : No
block Out Of Stock
Out of Stock
€516.25
Tax excluded
Quantity

It is able to switch from 4 to 12 independent electrical AC loads or three-phase loads by the switch actuators with maximum output of 16A per output and manual switch, as well as visible switching status.

There are same following programming functions for each output:

-time function: on/off delay

-staircase function with the warning and adjustable staircase lighting time

-scene, preset control: 8bit/1bit

-logic operation: AND, OR, XOR, gate function

-status response -forced operation and safe function

-threshold function setup

-control of electro thermal valve function

-selection of preferred status after bus voltage failure and recovery 

: KA/R 12.16.1
Out of Stock
New

Use collapsible tabs for more detailed information that will help customers make a purchasing decision.

Ex: Shipping and return policies, size guides, and other common questions.

  • Paste the label on a flat surface on the package
  • Make sure that both 1D and 2D barcodes are clearly visible
  • Ensure that the label is smooth and isn’t creased or wrinkled
  • Check for any tears, dents, holes or scratches
  • Pack your product tightly, with the right size packaging
  • Ensure both barcodes are on a flat surface of the package
Size S M L XL
Men 7-10 10-13 13-15 15-17
Women 7-9 10-12 13-14 15-16

Example Shown : SIZE XL, Hem to Hem 84cm OR 33 ,SIZE L, Hem to Hem 84cm OR 33 ,SIZE M, Hem to Hem 84cm OR 33 ,SIZE S, Hem to Hem 84cm OR 33

You might also like

Reviews

Write your review

GVS EIB/KNX Switch Actuator 12CH 16A Current Detection (12 DIN) ARCD-12/16.1

The switch actuators are the modular installation devices, with 2, 8 and 12 outputs for selection, using EIB BUS connection terminals to connect to the system. The switch actuators are connected to the AC power supply directly instead of an extra voltage supply. 

Write your review