- On sale!
- -20%
Datec Electronic AG EIB/KNX DALI ACTUATOR 1x8 Outputs
1630.03140/70100
New product
The Datec KNX/DALI Actuator 1x 8 Outputs is a device for controlling and monitoring up to 8 DALI ballast. Each lamp may also be controlled manually using the buttons on the device. Part of the monitoring is directly visible on the device itself. This is useful for commissioning lamps and test the installation even without KNX Programming. KNX bus Power is sufficient for this purpose.
Functional description
KNX / DALI Actuator for 8 independent DALI channels.
DALI supply included in the gateway, powered by the KNX bus:No need of external DALI power supply, no need of powering KNX/DALI Actuator with supply voltage.
1 KNX input / 1 DALI line output.
KNX and DALI are isolated with 4kV.
Each lamp can be set up, controlled and monitored independently
Each lamp can be tested in handmode by buttons on gateway
Lamps can be addressed physically or randomly
Lamp addressing can be done manually by buttons on gateway, or by KNX telegrams
LEDs for status indication of each lamp
Operating temperature -5°C … +45°C
Housing: 135 x 45 x 19mm (including connectors)
1630.03140/70100
New product
You might also like
-
![DATEC EIB / KNX ANALOG OUTPUT 0-10V 4CH (2 DIN)]()
![]()
- On sale!
- -20%
-
![Datec Electronic AG EIB/KNX DALI ACTUATOR 1x8 Outputs]()
![]()
- On sale!
- -20%
-
![Datec Electronic AG EIB/KNX Motor Control 230VAC +/- 10%, 50Hz F 100W]()
![]()
- -20%
-
![Datec Electronic AG EIB/KNX Switch Actuator 4x10A 8x Binary Inputs]()
![]()
- On sale!
- -20%
-
![Datec Electronic AG EIB/KNX Binary Input 8 fold & Status Leds 8 fold]()
![]()
- On sale!
- -20%
-
![D.E AG KNX Fancoil Actuator ANALOG 0-10V or PWM]()
![]()
- On sale!
- -20%
-
![D.E AG EIB/KNX Power Supply 640mA (6 DIN)]()
![]()
- On sale!
- -20%
The Datec KNX/DALI Actuator 1x 8 Outputs is a device for controlling and monitoring up to 8 DALI ballast. Each lamp may also be controlled manually using the buttons on the device. Part of the monitoring is directly visible on the device itself. This is useful for commissioning lamps and test the installation even without KNX Programming. KNX bus Power is sufficient for this purpose.